Air Injected Wedge mix-pour-foam While silicone can be used

While silicone can be used to create more flexible and lower cost molds

but may be increased up to 20%

Strength: 710-750 KSI

and 5-yard roll (#2100-C)

Orient this fabric so that yarns run parallel to expected loads

Air Injected Wedge mix-pour-foam While silicone can be usedExperienced fabricators will likely run across that hard to separate part, whether it's larger in nature or just stubbornwhich presents a challenge for demolding. Standard wedges only reach a few inches into any mold, and using force can result in damage. Applied air pressure provides a solution. Our #958 Air Injected Wedge is designed to deliver air all the way to the sticking point to provide pressure where it is needed most. Simply insert the wedge