Johnny Joint Rod End 2 Inch Machined Press-In 2 Inch X .500 Inch Ball Internally Greased Incl. Greasable Bolt Fits JL/JT Front End Housing (All Factory Axle Housings) RockJock 4X4 Cyclone V2 What you get is 43

What you get is 43

A pair of drive side and passenger side templates with both 97-02 and 03+ bolt hole locations

use warm water with dish soap to clean off any dirt spots

1 1/2 Inch or up to 2 Inch of additional bump stop

3-6 Inch Lift Height

Johnny Joint Rod End 2 Inch Machined Press-In 2 Inch X .500 Inch Ball Internally Greased Incl. Greasable Bolt Fits JL/JT Front End Housing (All Factory Axle Housings) RockJock 4X4 Cyclone V2 What you get is 43RockJock's Front Axle Housing Johnny Joint, single joint) for JL Wrangler, JL Unlimited and JT Gladiator vehicles replaces either front differential housing upper control arm bushing with a Johnny Joint rod end to get maximum articulation out of your suspension! This is a single joint only, see RJ 301000 101 for a complete kit. Finish is zinc plating.