SM74 Impression control recon PM52 Standard separator finger used on

Standard separator finger used on SM52 but also supplied as accessory on SM/CD/CX102

This is an all-new manufactured mounting ring for the numbering boxes on SM52 series presses

This is the vacuum feed tape for the SM52

Using the Press Parts jacket you will be confident that the print length will be correct and your job will register front-to-back

There are several variants in use so please check the picture carefully against your requirement

SM74 Impression control recon PM52 Standard separator finger used onThese are part of our Press Parts reconditioning process. The units are stripped and thoroughly cleaned in our own workshop. New seals and bearings are fitted and then the units are pressure tested before being put into stock. Press Parts back this with a 12 month warranty. This part is EXCHANGE ONLY Heidelberg equivalent: M2. 184. 1011 or M2. 184. 1181 This is the "square style" Bosch Mecman unit. Later presses were fitted with a round style Festo